Pro AV Catalog
Manufacturers
PRODUCT CATEGORIES
Matching Keywords
Model Numbers
Request Quote
All Products
120V Clear Connect Accessory Dimmer
Model: CCD-RD
Part #: FG2606-31-WH
- Clear Connect Enabled–Lutron's patented RF Technology uses a quiet band, essentially free of interference ensuring reliable communication between system devices
- Perfect Way to Add Light Control–Easily integrates with existing electrical infrastructures – simply replace the light switch
- Simple Web Configuration–Browse to the NetLinx® Clear Connect Gateway URL to quickly setup the Clear Connect Enabled dimmer
Product Info
Tech Specs
OVERVIEW
The Lutron Clear Connect CCD-RD is a 120V Accessory Dimmer that is used with CCD-6D-WH Clear Connect 600W Incandescent/MLV Dimmers. The Dimmer when added to a Clear Connect System provides light control to virtually any location, without pulling wires.
The Lutron Clear Connect CCD-RD is a 120V Accessory Dimmer that is used with CCD-6D-WH Clear Connect 600W Incandescent/MLV Dimmers. The Dimmer when added to a Clear Connect System provides light control to virtually any location, without pulling wires.
- Clear Connect Enabled–Lutron's patented RF Technology uses a quiet band, essentially free of interference ensuring reliable communication between system devices
- Perfect Way to Add Light Control–Easily integrates with existing electrical infrastructures – simply replace the light switch
- Simple Web Configuration–Browse to the NetLinx® Clear Connect Gateway URL to quickly setup the Clear Connect Enabled dimmer
- Warranty - Yes
- Operating Temperature (Maximum): 104 F
- Operating Temperature (Minimum): 32 F
- Certifications: UL, FCC
- AC Voltage: 120 Volts
- Warranty (Length/Type): 3 Years Limited
- Wattage (max capacity): 0.20 Watt
- Power:
- Power: 120 V 50 / 60 Hz
- Typical Power Consumption
- Dimmer / Switch: 0.2 W
- Test conditions: load is off and nightlight mode is enabled
- Remote Dimmer / Switch: 0 W
- Test conditions: load is off
- Surge Protection: To withstand surge voltages without damage or loss of operation, in accordance with IEEE C62.41-1991 Recommended Practice on Surge Voltages in Low-Voltage AC Power Circuits
- Power Failure: Power failure memory: should power be interrupted, the Clear Connect Gateway will return to its previous state when power is restored
- Environmental:
- Operating Humidity: 0 to 90%, Non-condensing
- Indoor use only
- ESD Protection:
- To withstand electrostatic discharge without damage or memory loss, in accordance with IEC 61000-4-2
- COMMUNICATIONS:
- Dimmers and switches communicate with the system through Radio Frequency (RF) and must be located within 30 ft (9 m) of a repeater
- Remote dimmers / switches are not required to be within a specific range of a repeater. System devices operate on frequencies between 431.0 MHz and 437.0 MHz
- Installation:
- Mounting Requires a U.S. wallbox. 3 . in (89 mm) deep recommended, 2 . in (57 mm) deep minimum
- Wiring Uses conventional 3-way and 4-way wiring
- Certifications:
- CSA , NOM, IC, COFETEL
Request Quote
Suggested Products
by
Crestron Electronics, Inc.
Thank you!
Someone will be in touch with you shortly.
Contact Create Spaces
close
Create Spaces
623 S Americana Blvd, Boise, ID 83702
Boise, ID 83702
USA
2083850507
https://createspaces.com/
Contact in regards to this product:
AMX
Model: CCD-RD
Request more information from a dealer near you
close
Request more information from a dealer near you